YTS - DT019 - DYE BRUSH

A wide straight-cut head, a contoured grip that stops the brush rolling, and a fine tail for parting.

A full-width tint brush with a solid straight-cut bristle block — it carries a good load of product and lays it down in a clean, even layer across the section, edge to edge. The head is built around an open loop that keeps the brush light in the hand, with a V-shaped lower edge that gives your fingers a defined place to sit. Below it the handle swells into a contoured mid-section grip, so the brush stays oriented in your hand through a long application instead of rotating, then tapers to a long fine point for parting and lifting sections without swapping tools.

Please note: these brushes are supplied in assorted colours and sold individually. Colour is allocated at random and cannot be selected. All colours are the same brush.

Key Features

• Wide straight-cut bristle head — lays a clean, even layer across the full width of the section
• Solid bristle block that holds a good working load of product
• Open loop through the head to keep the brush light and balanced
• V-shaped lower edge to the loop, giving a defined finger position
• Contoured mid-handle grip that resists rolling in the hand
• Long tapered tail for parting, weaving and lifting sections
• Sold individually, so you can build the number you need
• Assorted colours — supplied at random

What's Included

1 x Professional Hair Colour Tint Brush.

Colour supplied at random from the colourways stocked. Colour cannot be chosen at checkout and stock rotation varies. All colours are the same brush.

How to Use

1. Mix your colour, lightener or toner according to the manufacturer's instructions.
2. Part and lift your section with the pointed tail.
3. Load the brush by drawing the flat of the head through the product, coating the bristles evenly rather than overloading the tip.
4. Lay the product across the section with the flat of the head, working in smooth overlapping strokes.
5. Reload as needed and work through the head section by section.
6. Rinse thoroughly under running water immediately after use, working the bristles until the water runs clear.

Cautions

• For professional and adult use. Keep away from children.
• This brush is a tool, not protection. Always wear suitable gloves when handling colour, lightener, toner or any other salon chemistry.
• Clean immediately after use. Colour and lightener left to dry in the bristles will harden the head and splay the bristles permanently.
• Do not leave the brush standing or soaking in product, solvent or salon chemicals.
• Do not use the pointed tail against the scalp with any pressure — part with it, don't push with it.
• Inspect before each use. Retire the brush if the bristles are shedding, permanently splayed or hardened with residue, or if the handle is cracked.

Storage

Rinse clean and shake out the excess water, then store bristles-up or lying flat so the head keeps its shape. Standing a wet brush bristles-down bends the bristle set permanently. Keep away from direct heat and direct sunlight.

Every product is 100% original stock from authorised channels — never grey-market. NX is the sole distributor of Venash Professional & Alushe in Malaysia. See our full Authenticity Guarantee page for details.

No registration, no SSM certificate, no minimum order. Walk in to our Sungei Wang Plaza outlet, or WhatsApp +60 16-297 6299 for your salon's pricing — single units and bulk both welcome.

Electrical tools are covered by a warranty handled directly by NX in Kuala Lumpur — typically 1–12 months depending on the product. WhatsApp us or visit our outlet with proof of purchase to claim.