CURETVLON - M-007 - CURLING TONG - 25/28/32/36/38MM

Five barrel sizes, one digital control system — from tight defined curls to soft open waves.

The CURETVLON M-007 is a clamp-style professional curling tong built around a PTC heating barrel with a digital LED temperature readout. Temperature is set in 10°C steps across an 80–230°C range, so the same tool covers fine, colour-treated hair at the low end and coarse, resistant hair at the top. The polished chrome-finish barrel is paired with a spring-loaded clamp, an insulated cool tip and an insulated lever, and the whole range shares the same handle, controls and heat system — the only thing that changes between models is barrel diameter.

Key Features

• PTC heating barrel with a digital LED temperature window on the handle
• 80–230°C adjustable temperature, set in 10°C increments using the + and − keys
• Heat-up indicator — the temperature display flashes while heating and holds steady once the set temperature is reached
• 60-minute auto power-off, with any key press returning the tong to working mode
• Long-press power on — hold the power key for 3 seconds to switch on
• Heat-resistant anti-slip strips run along both sides of the barrel to stop hair sliding during winding
• Insulated cool tip and insulated clamp lever for a safe second hand position
• 360° swivel power cord to prevent twisting and tangling during use
• Spring-loaded clamp plate holds the section flat against the barrel
• Rated 220–240V ~ 50Hz

What's Included

One curling tong and one instruction manual per unit. Choose your barrel diameter:

All five sizes share the same handle, digital controls, PTC heat system and temperature range.

How to Use

1. Remove the tong from its packaging and connect it to the power supply.
2. Press and hold the power key for 3 seconds. The temperature display will light up.
3. Use the + and − keys to set your temperature. Each press adjusts by 10°C within the 80–230°C range.
4. Wait until the display stops flashing and holds steady — the barrel is now at your set temperature.
5. Working on clean, dry hair, take a section, open the clamp, position the section and wind it around the barrel.
6. Hold briefly, then release the clamp and slide the tong away.
7. If the tong sits idle for 60 minutes it will power down automatically. Press any key to resume.
8. Switch off, unplug and allow the tong to cool completely before cleaning or storing.

Cautions

• For professional and adult use. Keep out of reach of children.
• Do not use near water. Never use in the bath or shower, or near a bath, basin or any vessel containing water. Do not immerse in water.
• Do not leave the appliance unattended while it is connected to the power supply.
• Use on dry hair only. Do not use on wigs, hairpieces or synthetic hair.
• The barrel becomes very hot in use. Avoid contact between hot surfaces and the skin or scalp.
• Do not hold the tong on one section of hair for more than a few seconds — prolonged contact can damage the hair.
• Check the cord for damage before each use. A damaged cord must be replaced by the manufacturer, its service agent or a similarly qualified person.
• Do not place the appliance on heat-sensitive surfaces, and keep it away from flammable materials such as towels and clothing.
• Do not wrap the cord around the appliance.
• Always unplug after use.
• If styling products are used, clean the barrel once the tong has cooled to prevent build-up.
• Use only for hair styling. Do not use for any other purpose.
• Not recommended for use by persons with reduced physical, sensory or mental capabilities, or lacking experience and knowledge, unless supervised or instructed by a person responsible for their safety.
• At end of life, take the appliance to a designated recycling point rather than disposing of it with household waste.

Storage

Switch off, unplug and allow the tong to cool completely before storing. Store in a dry place away from water, direct heat and direct sunlight. Do not coil the cord tightly around the body of the appliance — loop it loosely to protect the wiring at the swivel joint.

Every product is 100% original stock from authorised channels — never grey-market. NX is the sole distributor of Venash Professional & Alushe in Malaysia. See our full Authenticity Guarantee page for details.

No registration, no SSM certificate, no minimum order. Walk in to our Sungei Wang Plaza outlet, or WhatsApp +60 16-297 6299 for your salon's pricing — single units and bulk both welcome.

Electrical tools are covered by a warranty handled directly by NX in Kuala Lumpur — typically 1–12 months depending on the product. WhatsApp us or visit our outlet with proof of purchase to claim.